Is the license file in the right place? It should be in the Mach3 folder, but not in a subfolder. It sounds like the program can't find it, or the file's corrupt.
Hi all ! I need your help ! I can't figure out why mach3 stops in the middle of my program. No errors, no limit switches triggered. Licenced version !
Thanks in advance !
Similar Threads:
Is the license file in the right place? It should be in the Mach3 folder, but not in a subfolder. It sounds like the program can't find it, or the file's corrupt.
[FONT=Verdana]Andrew Werby[/FONT]
[URL="http://www.computersculpture.com/"]Website[/URL]
Yes the licence file is in the right place. I did retry the gcode and it stopped at line 473 this line. It is very weird ...
In the Title bar, is says "Licensed to " and your name?
Is the entire toolpath displayed, or only up to where it stops?
If you don't see the entire toolpath, it's a license issue.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
And, yes in the Title bar, is says "Licensed to " and my name.
Thanks
Sounds like I'm having same issue here. Mach3 just stops no error no switches triggered, nothing flashing, please help. Tried to change denounce, no result.