Need Help!- How to calibrate table?
Registered
How to calibrate table?
When I cut straith lines on X or Y the cut is fine ( nice cut no jageth edges ) but when I cut curves and angels my cut is very jaget almost like a saw tooth.
How do I correct this? Similar Threads:
Member
Re: How to calibrate table?
Try reducing your speed on the curved cuts and see if the problem goes away. It could be whip in the axis movements.
Registered
Re: How to calibrate table?
Hi rat,
Think it must be your drawings on dxf try a different resolution .
Need Help!- How to calibrate table?
Tags for this Thread
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules