Config > Homing/Limits, and check the Reverse box to change direction.
I just installed mach 3 on my new 3040D and x,y,z move wrong. Moves up instead of down and left instead of right and so on. I do not understand how to fix this so could somebody explain this to me. The manual tells me to go to page 10 and follow the steps, but page 10 has nothing to do with what is wrong.
Thank you in advance,
Dennis Killian
AKA capdenny
Similar Threads:
Config > Homing/Limits, and check the Reverse box to change direction.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
You need to configure the motor outputs.
Thank You Gerry