Reply with QuoteSounds like you are in step mode.
FRO not working
I bought a new CNCRP Pro 4896, installed the version of Mach3 they recommended. Also used their xml file.. I also installed an XHC pendant..
My problem is, when I use the arrow keys to jog, it moves about .028 (different each time).. on the pendant, it moves about .020 but will come back to the same place if I turn the wheel back.. I turned it to 2% for .001 but it still moves .020+ each time. When I try to adjust the FRO, doesn't matter if it all the way down or up, nothing changes in the speed of movement..
Is there some way to adjust this?
Similar Threads:
Re: FRO not working
Sounds like you are in step mode.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
