Uncheck Home Negative in Config > Homing
Uncheck Home Negative in Config > Homing
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Unchecked it.Z went up to upper limit switch,stopped,then traveled down to lower limit switch.
Not sure if problem is in software.X and Y home out and stop.Thanks for help.