The Pokeys people are probably the best ones to ask.
There aren't a lot of Mach4 users, and most of the plugins are in beta state, so there are very few people with experience in the different motion controllers.
Hi,
I have had a search and can't seem to find any info. I have downloaded the trial of both mach3 and mach4 as well as the pokeys plugins.
On Mach3 I was able to map an encoder to control the feed rate override easily, however I can't seem to find a way to do it on Mach4.
Any help would be appreciated,
Cheers
Sent from my iPhone using Tapatalk
Similar Threads:
The Pokeys people are probably the best ones to ask.
There aren't a lot of Mach4 users, and most of the plugins are in beta state, so there are very few people with experience in the different motion controllers.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks for your reply ger21.
Sent from my iPhone using Tapatalk