| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
07-31-2009, 12:21 PM
| |||
| |||
| EMC does not support the PCL832, it may be possible to write a driver, but it looks like the PCL832 is a "smart" motion controller and EMC really wants to be in direct control of motion, so a "dumb" interface is more appropriate. Also, its probable that your motherboard with ISA slot will be too slow to run EMC or any more modern control software. You can get new motherboards with ISA slots (up to Core Duos!) but these will likely cost more than a new interface card.  |
|
| Tags |
| pcl832 pcl 832 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- EMC2 | Jamy | LinuxCNC (formerly EMC2) | 32 | 08-17-2009 11:03 PM |
| EMC2 | Jamy | General CAD Discussion | 2 | 12-11-2008 12:02 AM |
| EMC2 HELP HELP HELP | Alwyn | OpenSource Software | 2 | 10-11-2008 11:18 AM |
| Need Help!- M8 still not being red by EMC2 | SpeedsCustom | LinuxCNC (formerly EMC2) | 27 | 04-13-2008 03:36 PM |
| Emc2 | sdantonio | Mach Mill | 2 | 02-05-2007 02:26 PM |
| | |
Linear Mode
