How to change the homing sequence...

[jbcj]

Hi all,

I have had alot of sucess so far in my setup. But I am having a problem with the homing sequence. I am looking for where and how you modify this....


Jim

[CalG]

Enhanced Machine Controller (EMC)"
You will need to do a search and regester etc.

Good bunch there!

Cal

[jmelson]

Hi all,

I have had alot of sucess so far in my setup. But I am having a problem with the homing sequence. I am looking for where and how you modify this....


Jim

On linuxcnc.org, under documentation, there is a section of pdf files, you want the "integrator's manual". On page 34, it describes all the homing options. It depends to some extent whether you have encoder feedback to the PC or not. But, it is all in there.

Jon

[jbcj]

Jon, Ca,

Thank You

I have now resolved my problem..... The homing now works... On to the next problem..

Jim

[Big John T]

You might get better results with one of these contact methods to the EMC community.

http://www.linuxcnc.org/content/view/4/8/lang,en/

John