Need Help!- Board Selection for servo and stepper

[Kel05]

I have 2 question
First:
I have 3 servo amplifier (MR-J3A) and AC servo motor (HF-KP series) from mitsubishi. What kind or type of board/boards that suitable to control those servo amplifiers and drivers? Is CNC4PC C11 boards can control those mitsubishi servos system?
Second:
Is there any kind/ brand of board using EMC Linux that can control both servo and stepper driver?
THank you....

[DonnieET]

Check out the 5i23 PCI card and the 7i33 daughter card from Mesa electronics http://www.mesanet.com/ I'm running Old Hurco servos with them.

Donnie

[Kel05]

Thank you for your response... I have another question... Mesa has an PCI interface. How to program the I/O of Mesa boards with EMC sotware.Thank you

[chester88]

EMC uses HAL (hardware abstraction layer) to control harware. It works much like electrical connection (pins and signals)
specifically with mesa products and usings HAL's hostmot2 driver you can control steppers and servos and general purpose input/output.
There are other options: see this page for some ideas:
http://wiki.linuxcnc.org/cgi-bin/emc...orted_Hardware