What CAM are the EMC guys using? - CNCzone.com-The Largest Machinist Community on the net!

flash319 · #1 04-07-2009, 09:05 AM

So I have Autodesk Invetor and almost have my 4X8 table done. I was wondering what CAM programs EMC users are using?

Big John T · #2 04-08-2009, 02:19 PM

If you mean 4' x 8' I assume it is a plasma table. I use sheetcam.

John

vlmarshall · #3 04-09-2009, 06:52 PM

No Linux-based CAM programs on my mill computer, I use a Windows machine for that, and everything else.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)