Aloha ya'll - working to get this assemblage running

As stated we've got a
Sherline 5400
3 k179 stepper controllers
z-axis ='s step syn motor (p/n 2462561) rated at 2 degrees per step 1.4 Amps, 4.5 Volts
x,y axis ='s astrosyn miniangle stepper (type 231 mc705) 1.8 degrees per step 2.4 Amps, 3 Volts

and we'd like to see this machine work with EMC. As a total novice in this realm we need some help getting the .ini and .HAL files prepared (I think that's what is needed - again, total novice here)

Ran the configuration wizard & see a list of variables - listed here as at the end of the day hope to fill in the blanks for any future novices - could someone please lend a hand? Thank you in advancee

From K179 controllers
Step time ns
Step Space ns
Direction Hold ns
Direction Setup
Parport Base Address
Latency test result

Motor steps per revolution
Drive microstepping
Pulley Teeth (motor:leadscrew)
Leadscrew Pitch mm/rev
Maximum Velocity mm/s
Maximum Acceleration mm/s2

Home Location
Table travel (a to b)
Home Switch Location
Home Search velocity
Home latch direction

Spindle Configuration
PWM Rate
Calibration
Speed 1:
Speed 2: