| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-27-2009, 10:16 PM
| |||
| |||
This is now working in Axis/emc2 from a fresh check of CVS-I have checked it out in sim, not on a real machine yet: 1. start a program 2. stop in the middle of the program (maybe the tool needs to be changed) 3. jog the head up 4. change your tool (I haven't tried touching the simulated too off yet) 5. reload the tool table 6. under the 'Machine' menu item- select 'Run from selected line' 7. the tool changes to the correct size and starts where I left off. 8 Yay! I just wanted to point out to all the people who wondered if axis/emc2 could start in the middle of a program that this does work. You could start in the middle of a program in emc, even in the old xemc days, but I don't think the reload tool table edit trick was working then. Dan  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using work on selected faces problem | BJ-DEKA | SolidCam | 0 | 06-10-2008 10:05 AM |
| Selected Block Not Addressed | Hotrodder2u | Bridgeport and Hardinge Mills | 2 | 08-02-2007 09:14 AM |
| No drive surfaces selected | justCNCit | Mastercam | 21 | 08-18-2005 10:55 PM |
| Single line mode works well, Auto is not soo good?? | Darc | CamSoft Products | 16 | 10-26-2004 03:29 PM |
| G codes how does works at one line? | bunalmis | General CAM Discussion | 3 | 07-26-2003 08:49 PM |
| | |
Linear Mode
