Need Help!- HAL and INI files

[dodo00700]

Halo people I'm Robert Lovreković a student of electroengenering and I'm trying to power some motor with EMC2. I did it with stepconf wizard and it worked but now i have to write the ini file and hal. I have some files written but i cant start the files. Every time i try to start the INI file it show me in the terminal all commands and next to it Command not found

I really do not know where to post this problem so if you now where please tell me or if you now what could bee the problem please help

sorry for my English

[audioandy1762]

Hi

Sorry I cannot help directly but you might find help here.

http://www.distinctperspectives.com/emc2installsetup/

This was posted on another thread here on the forum.

Andy

[dodo00700]

Thank you for replying, in the link you sand me I found something that might
help

[unterhaus]

I assume you have looked at linuxcnc.org? The manuals help a lot. Also, if you have a specific problem, the #emc IRC chat on freenode is a good place to get help as you sit at your computer. There is a small problem in that a lot of the active people in that channel probably are only monitoring the thread for about 20 hours a day, so there is a slack time which may not match with your schedule.