UBUNTU 8.10 Upgrade - CNCzone.com-The Largest Machinist Community on the net!

djmickyg · #1 11-01-2008, 06:41 PM

Hi all,

Ive just upgarded my EMC2 to the new ubuntu 8.10 (with the internal upgarde manager) and now EMC2 errors on startup and doesnt work

has anyone else tried this??

acondit · #2 11-01-2008, 09:05 PM

You probably got a new kernel and are now not loading the real time modified kernel.

Alan

Dan Falck · #3 11-01-2008, 11:28 PM

8.10 is not supported. You need to stick with 8.04.
Check out the top of this page:
http://wiki.linuxcnc.org/cgi-bin/emc...cKnowledgeBase

djmickyg · #4 11-01-2008, 11:33 PM

well that's no good for me..
lucky it's not hooked up to the router just yet..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Do you have to use ubuntu?	phantomcow2	LinuxCNC (formerly EMC2)	11	10-03-2010 06:46 AM
Ubuntu & Linux EMC	pepperwood	LinuxCNC (formerly EMC2)	1	01-16-2008 03:41 AM
Ubuntu 6.06 vs Ubuntu 7.1	piedpiper	LinuxCNC (formerly EMC2)	12	01-13-2008 11:41 AM
not ubuntu	Mr Bits	LinuxCNC (formerly EMC2)	22	12-19-2007 08:12 AM
Ubuntu 6.06 & EMC2	tenmetalman	LinuxCNC (formerly EMC2)	19	10-11-2006 09:23 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)