| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-23-2008, 03:04 PM
| |||
| |||
Hello! I have got ball screw 5mm/rev pitch. Encoders 2500CPR. Its scale 2000 Now ,my question is how to write commands for X axis in diameter and not radius? Should i change scale or does it exist any other G code and char for this? Thank you Marko  |
|
#2
10-23-2008, 03:30 PM
| |||
| |||
| I assume you're talking about a lathe? Lathe support is pretty new to emc2. You can only program in radius mode. (on the axis display there is a diameter readout.) Patches are welcome for adding diameter gcode programming. sam |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
