| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-18-2008, 12:22 AM
| |||
| |||
I am researching on using EMC2 controller in a real VMC. I have some base knowledge about EMC2. But I wonder much about HW that I will use to connect with the EMC2. I see some HW in the web linuxcnc.org. But I don't know what kind is the most suitable for VMC and has a good price. Please give me some advices about the HW, especially about motion card that use to control servo motors  |
|
#2
07-20-2008, 11:53 AM
| |||
| |||
| Hmm, no responses. This forum may not be the place for advice involving machining centers. Try something here. http://www.linuxcnc.org/content/view/4/8/lang,en/
__________________ Anyone who says "It only goes together one way" has no imagination. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advices on these drivers | Niggo | General Electronics Discussion | 0 | 07-01-2008 12:29 AM |
| Need advices for mold and foam | yoonjung | Moldmaking | 5 | 04-03-2008 05:39 PM |
| Advices on G203 before purchase | RemPat | Gecko Drives | 2 | 03-28-2007 02:04 PM |
| newbie looking for advices | marc ham | Open Source Controller Boards | 2 | 01-13-2007 05:40 AM |
| Need some startup advices... | b_cybe | DIY-CNC Router Table Machines | 15 | 03-16-2006 04:18 PM |
| | |
Linear Mode
