were do I start - CNCzone.com-The Largest Machinist Community on the net!

01-07-2008, 11:18 PM

car84

Join Date: Jan 2008

Location: usa

Posts: 1

were do I start

permalink

I have a forth axis and drive that will take step comands

I need a control that will run the fourth turn no the brake (air cyl.)

then turn a table power feed I will be using to put hex flats on a lot of shafts

what ver. and how to set up m code to run power feed on brigeport mill

Thanks
car 84

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I don't know where to start...	Fluxion	Mach Wizards, Macros, & Addons	2	09-11-2007 11:40 AM
Single start vs double start ballscrew.	darik	Linear and Rotary Motion	13	03-21-2007 07:53 PM
No start	chipsterns	Machine Problems, Solutions , Wireless DNC, serial port	1	10-10-2006 09:22 AM
New to CNC, Where to start?	RedLabel	DIY-CNC Router Table Machines	16	06-26-2006 06:27 PM
start	steveo	Mazak, Mitsubishi, Mazatrol	5	03-12-2006 10:59 AM

All times are GMT -5. The time now is 02:58 PM.