Stepconf information for Kl-5056 drivers needed - CNCzone.com-The Largest Machinist Community on the net!

jcorrea · #1 11-15-2007, 04:59 PM

Hi,
Just start using the new Stepconf utility from EMC2 Ver. 2.2.1. So far I like it very much. I have the KL-5056 drivers and need to find out the correct values for the STEP TIME, STEP SPACE, DIRECTION HOLD, and DIRECTION SETUP. Can I use the Gecko drivers values? Any help would be greatly appreciated.

Thanks,
Jorge

jcorrea · #2 11-25-2007, 03:29 PM

Just found the values I needed from the KL-5056 spec's;

STEPLEN: 1200ns min
STEPSPACE: 1200ns min
DIRSETUP: 5000nS min
DIRHOLD: 5000ns min

Thanks

djmickyg · #3 11-30-2007, 01:33 AM

are these the same values for the KL-4030?? I'll be setting this up soon.
thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
425 oz. Motors 5056 Drivers and new PSU	Cartierusm	Automation Technology Products	4	04-21-2008 02:37 PM
SEW eurodrive servodrive information needed	boutje	Servo Motors and Drives	0	02-23-2006 02:20 PM
Japan Servo Co. Some information needed	phantomcow2	Stepper Motors and Drives	4	08-12-2005 11:08 PM
Information needed for upgrade	Hack	DIY-CNC Router Table Machines	20	07-01-2005 10:17 PM
information needed on spindle assembly	intelsingh	General Metalwork Discussion	3	02-23-2005 08:49 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)