File permission

[jackfisher]

I'm trying to configure the pin outs on EMC2 but when I go to save the modified standard_pinout.hal file I get an error that tells me that I'm not the owner and I cannot save the file. I have gone to the properties of the file and I'm not allowed to change any of the properties of the file. Any suggestions?

Thanks

Jack Fisher

[samco]

you need to copy the configs to your home directory. The config files are samples only.

http://wiki.linuxcnc.org/cgi-bin/emc...onfigsOnUbuntu

sam

[jackfisher]

Thanks I'll give that shot.

Jack Fisher

[jhwatts]

You need to run the file manager in super user mode. This will allow you to copy files to any directory unrestricted.