EMC + HobbyCNC driver help. I have no linux knowledge.

[Big John T]

Originally Posted by cnccadcam I also have a hobbycnc board. I have the 4AUPC. I also need timing requirements. Step Time Step Space Direction Hold Direction Setup C

After some teeth pulling I did get a bit of info on step translation chip on this board and added it to here:

http://wiki.linuxcnc.org/cgi-bin/emc...r_Drive_Timing

remember that signal conditioning and opto isolation can increase timing requirements. That's why you need to know the timings for a driver board, not just the step translator chip that is contains

John

[kpmerrill]

Has anyone used EMC with Tormach PCNC 1100?

[Big John T]

I see that this is your first post so FYI, when you have a new topic you normally start a new thread and not hijack someone else's thread. You will get better response that way...

Also, check out the EMC IRC and mailing list as there is many more EMC'ers over there...

John