EMC2 hands on - CNCzone.com-The Largest Machinist Community on the net!

helpmeout · #1 12-21-2011, 11:43 AM

Who in the Little Rock AR. has a cnc running on EMC2 that I might talk to, or visit and see first hand how this system runs. I would be very grateful. Just P.M. with any info you may have. even talk to on the phone

svenakela · #2 12-25-2011, 10:08 AM

Originally Posted by helpmeout

Who in the Little Rock AR. has a cnc running on EMC2 that I might talk to, or visit and see first hand how this system runs. I would be very grateful. Just P.M. with any info you may have. even talk to on the phone

I'm pretty sure you'll have a greater chance of getting an answert if you ask at the EMC2 mailing list (see the web site for getting-there-instructions).

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NORTH SYD: Newbie would really appreciate some hands-on help	rthorntn	Australia, New Zealand Club house	0	11-07-2011 04:46 PM
A show of hands.....	pete from TN	Benchtop Machines	67	02-22-2011 10:19 PM
Got my hands on a Dahlgren CNC router for $100	samim	DIY-CNC Router Table Machines	18	07-15-2009 03:14 PM
Newbie- Getting my hands dirty	DieselTwitch	General CNC (Mill and Lathe) Control Software (NC)	0	02-20-2009 04:43 PM
RFQ: Looking for someone who can make watch hands	amanson	Employment Opportunity	6	07-31-2008 07:26 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)