Spindle Recommendations

[TZak]

I have a 3 axis router table running emc2 with a standard porter cable 619 1.25hp router. I wanted to know if anyone has any recommendations for a proper spindle which I can tie back into emc2. I have seen some chinese water cooled one's on ebay but am a little hesitant in getting something like that.

I am mainly cutting wood, acrylic and some aluminum.

Does anyone have any suggestions? Or where I should start looking.

Thanks

[acondit]

Since you already have a router, RomanLini designed a SuperPID interface which allows a common router to be tied into EMC2 for speed control. The thread that I show above has a lot of info on it.

Alan