| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-27-2011, 08:57 AM
| |||
| |||
Hello when I loged on it was suggested for me to post a hello message, but the message didn't say where. So since I have an intrest in EMC, why not here. Hello everybody. A little about me. I have many hobbies. Electronics, Pic programming, CNC, and drawing. plus just about anything I get my hands on. Right I am in the middle of making a CNC machine Using EMC-2 software. The machine is for routing PCB's. I have a good start but I need to learn more about it befor I can open my mouth. So I will read and learn for now. Thank you for your time gogo  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Special post for presentation! Laser manufacturers/dealers post their contacts here! | Litografa | Laser Engraving & Cutting Machines | 1 | 06-22-2010 01:23 PM |
| Need post Delcam PowerMILL post for Hardinge VMC 600 II with Fanuc Series oi-MB | littlem | Post Processor Files | 0 | 10-26-2006 04:59 PM |
| | |
Linear Mode
