| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-05-2011, 11:19 PM
| |||
| |||
Newb here looking for cnc plasma table advice. Sorry, if this has been asked a million times. So far here is what I have come up with. Gecko G540 Motor Control candcnc.com Torch Height Control MP3000E-DTHC 4 stepper motors Power supply EMC Am I even close?  |
|
#2
03-12-2011, 01:39 PM
| |||
| |||
| I'm not familiar with torch height control, but the one you linked may be designed for use with Mach. EMC can interface with darn near anything, but there might be easier choices for EMC. I would recommend asking on the emc-users mailing list or IRC channel: LinuxCNC.org - Community As for the rest of the setup, the G540 definitely works well with EMC, so you're getting warmer at least. |
|
#3
03-12-2011, 04:27 PM
| |||
| |||
| I believe Big John is using Mesa's torch height control: THCAD High isolation A-D accessory on this page: AIO Daughter cards He might chime in here.... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- electronics | dreamci | General Electronics Discussion | 30 | 12-08-2010 09:47 AM |
| Electronics... | Stiggero | DIY-CNC Router Table Machines | 2 | 01-21-2010 05:12 PM |
| DIY CNC Electronics | Paul_P | General Electronics Discussion | 1 | 12-25-2009 01:15 PM |
| Electronics | Bassbuilder | General Electronics Discussion | 2 | 11-15-2004 09:34 PM |
| Electronics help | chuckknigh | DIY-CNC Router Table Machines | 4 | 07-18-2003 09:09 AM |
| | |
Linear Mode
