| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-11-2010, 07:47 AM
| |||
| |||
I am trying to cut some gears out of MDF. I am using a 5mm router bit to cut a 10mm hole in the gear center,but the holes are not quite round, they look slightly egg shaped. I have set backlash compensation with a dial guage. I have tried different speeds and feeds but no improvement. Anyone else have this problem?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Anilam 3000m Not cutting round hole! | mac51r | General CNC (Mill and Lathe) Control Software (NC) | 0 | 09-03-2010 09:58 AM |
| 2D Contour on a round OD not very round :( | kojack | Mastercam | 5 | 08-10-2008 07:07 PM |
| Need a hole that LOOKS round | Art Ransom | Mechanical Calculations/Engineering Design | 12 | 06-27-2008 10:52 AM |
| NEWBIE HELP>> How do you input a drill hole or extrude a hole that is.. | l u k e | Solidworks | 9 | 02-11-2008 10:54 AM |
| job setup -round whit a hole | osomaker | Mastercam | 10 | 12-21-2006 08:51 AM |
| | |
Linear Mode
