| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LinuxCNC (formerly EMC2) Discuss LinuxCNC (formerly EMC2) Controlers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-14-2010, 01:35 AM
| |||
| |||
I recently upgraded to 2.4.2 and I think I may have found a bug. If I select 'reload tool table' under the file menu, my tool selection, and cutter comp quit working. Down on the bottom of the screen where it normally would list a tool diameter and number, it just says 'no tool' and I can't do anything to change it, unless I restart EMC. Can/has anyone else been able to duplicate this? Brian  |
|
#2
07-14-2010, 02:07 AM
| |||
| |||
| You need to post this on the emc mail list. https://lists.sourceforge.net/lists/listinfo/emc-users not many developers read the 'Zone |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
