More information. People say that EMC2 uses the same commands as a Fanuc control, yet EMC2 doesn't recognize M98 and M99. I've read over and over about O100 or 0100 labeled subprograms, but still don't understand the full workings of how they relate to say a Fanuc6M post that uses M98 to call, and M99 to end subprogram. EMC2 G98 and G99 don't seem to be the same commands. The EMC2 manual and quick G-code guide do not give much in the way of examples, and my tech school book doesn't use EMC2's protocols for G-code writing.
My Anilam M and Fanuc Posts in Dolphin Part Master does fine for none subprogram posts, but the minute I start getting involved with subprograms there are problems. I have the PP manual for Partmaster posts, but need subprogram example to make the changes needed.