Emc and Kollmorgen ServoStar CD ver 2 or 5 compatability??? - CNCzone.com-The Largest Machinist Community on the net!

KS_WGB · #1 04-29-2010, 01:43 AM

Has anyone integrated a Kollmorgen ServoStar CD ver 2 or 5 with Linux EMC? Does EMC support this particular servo drive? Is this even possible? Any help or links are much appreciated.

Thanks

PCW_MESA · #2 04-30-2010, 09:38 AM

As long as it has a +- 10V analog input (either velocity or torque mode)
or (less desirable), step+ dir inputs, it should be compatible.
At least some of the ServoStar models have these capabilities.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- ServoStar CD amplifier for CNC router	Oleks	Servo Motors and Drives	37	11-13-2010 06:55 PM
Getting the CD servostar enabled	mackeym	Servo Motors and Drives	8	10-12-2010 07:40 PM
Kollmorgen Servostar and Moog Servo Drivers	MaelXD	Servo Motors and Drives	2	03-12-2010 05:58 AM
Kollmorgen DC replacement	bigalow	Servo Motors and Drives	21	09-26-2008 09:01 PM
Kollmorgen PMI servodisc U12M4	lucas	Servo Motors and Drives	2	02-01-2006 06:35 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)