Hi i
am aware of the thread from 2012
i have now in 2016 similar problem we have 2 Granite VDE and for the Z Axis an Delta Drive and servo. The Delta works perfect-
Now my issue i also need an 5v + for enable but when i measure pin 1 to 6 i should get 5v i read 0,22V
no matter what i do i don't get 5v my workaround would be the Enable always on 5+v
so my question is is there an easy way around or do i have to do an PCB with optocoupler which does get 24V from Out signal to convert to the Enable signal ? I expect that almost everyone has this isseo ?
any help would be nice
thomas
Hi PCW_Mesa wow that is fast thank you i appreciate it
i thought about this so i will use the Step+ from the 6th axis for enable and when the System get powered on the servo is enabled.
But i thought i could use the 5pv Pin 6 for instance why does it show 0,22v ?
Reading the Manual https://granitedevices.com/assets/fi...160_manual.pdf i interpret that everything else than Enable and Fail is Opto coupled - (page 5 ) But i am not sure chapter 7.4 page 13 says optocoupler
pin 10 and 11 is used for IN3 = Enable out 2 = error ? I am afraid to grill the device but maybe it should work out well ?
best reg thomas