problem with my LinuxCNC


Results 1 to 4 of 4

Thread: problem with my LinuxCNC

  1. #1
    Registered
    Join Date
    Nov 2008
    Location
    maroc
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default problem with my LinuxCNC

    Hello I have a problem with my LinuxCNC

    I run the "LinuxCNC Stepper" I complete my setup and I test each axis separately, it works very well,

    Once I finish the configuration and I run the shortcut created on the desktop, I can no longer control my axes.


    Another note: when I launch the shortened engine is released, as if I hit the power

    Someone has already experienced this problem?

    thank you for helping me

    Similar Threads:


  2. #2
    Member
    Join Date
    Feb 2007
    Location
    usa
    Posts
    711
    Downloads
    2
    Uploads
    0

    Default

    there are 2 buttons on the top left of the screen. click the left, then right one.

    left one is "toggle emergency stop" shortcut F1
    right one is "toggle machine power" shortcut F2

    hopefully that is your problem.
    Otherwise did you have to set up a charge pump?
    tell us what hardware you are using.



  3. #3
    Registered
    Join Date
    Nov 2008
    Location
    maroc
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default

    I already remove the emergency stop and I put the machine
    I just use a map interface HY-JK02-M 5
    driver and stepper motor wantaiMOTOR



  4. #4
    Registered
    Join Date
    Apr 2005
    Location
    Finland
    Posts
    16
    Downloads
    0
    Uploads
    0

    Default Re: problem with my LinuxCNC

    i just setup my linuxcnc whit hy-jk02-m board and working fine drivers have hy-vin268n-5A, only speed have cslow if make acceleration up 15mm/sec lost step. mach3 not working anything good, if bush button Y move X and y sametime or stay motors run. i no know why but i instal linux and now working fine first test have ready and carwing "linuxcnc" text yesteday fine. but how i can move etc, spirar , example in to working area box (have in display red line) have out of working area alltime ? why and how move ecample g-gode to in area ?
    and were found now 3 axis 7-segment dispaly this board ? and hand manual controll box who can set speed, axis up /down manual and other buttons what this need, or were have diy project how build hand wheel and button box ?



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

problem with my LinuxCNC

problem with my LinuxCNC