i just setup my linuxcnc whit hy-jk02-m board and working fine drivers have hy-vin268n-5A, only speed have cslow if make acceleration up 15mm/sec lost step. mach3 not working anything good, if bush button Y move X and y sametime or stay motors run. i no know why but i instal linux and now working fine first test have ready and carwing "linuxcnc" text yesteday fine. but how i can move etc, spirar , example in to working area box (have in display red line) have out of working area alltime ? why and how move ecample g-gode to in area ?
and were found now 3 axis 7-segment dispaly this board ? and hand manual controll box who can set speed, axis up /down manual and other buttons what this need, or were have diy project how build hand wheel and button box ?