Bearings wihout flanges - CNCzone.com-The Largest Machinist Community on the net!

07-04-2009, 02:00 PM

exit104

Join Date: Mar 2009

Location: United States

Posts: 2

Bearings wihout flanges

permalink

I have a set of 2 Nippon Bearing linear slide rails with SW12G open slide bushings and a WA 12, fully supported base. The bearings are just sleeves, they have no flanges, just a couple of slots for retaining rings.

I expected to be able to get housings for the bearings that would allow me to connect them to the gantry. Alas, I cannot find housings without bearings already in them.

So, what is the proper way to connect these bearings to a gantry? Do I need to create a custom fixture or am not looking in the right places for the housing?

Thanks!

__________________
Andy Otto
-*Andy*-

Last edited by ger21; 07-04-2009 at 03:33 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what machine to do cut 1/2in flanges?	MaxQ	General Metalwork Discussion	1	08-11-2007 12:08 PM
RFQ Aluminum pulley flanges	kmcwhq	Employment Opportunity	5	03-22-2007 09:20 AM
:RFQ: 2 304SS Flanges	CarTunr22	Employment Opportunity	2	03-05-2007 09:48 PM
Bonding flanges to a timing pulley?	Chris D	Welding, Brazing, Soldering, Sealing	8	10-01-2005 08:37 AM
Machining exhaust flanges	pauls	General Metalwork Discussion	8	03-15-2005 11:12 AM

All times are GMT -5. The time now is 12:15 PM.