| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Linear and Rotary Motion Discuss ball/Acme screws, R&P, linear slides and theory here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-17-2008, 07:36 PM
| |||
| |||
I purchase some really nice 41" kuroda ball screws that have rotary encoders on them. I'm new to all this, and didn't plan on buiilding anyhting this elaborate, but since they are there, what would it take for me to enable them in my router? Thanks mark    |
|
#2
12-17-2008, 07:59 PM
| ||||
| ||||
| What software are you using and do you use steppers or servo's? Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Do i need rotary encoders for accuracy? | abomination | Stepper Motors and Drives | 4 | 04-27-2007 10:02 AM |
| Where to buy rotary encoders on Oz? | Splint | Australia, New Zealand Club house | 2 | 04-25-2007 03:19 AM |
| Rotary Encoders | frankg521 | General Electronics Discussion | 51 | 03-23-2007 09:56 PM |
| rotary encoders...worth it? | gearsoup | Mechanical Calculations/Engineering Design | 6 | 02-27-2006 02:59 AM |
| Sources for Rotary Encoders | ViperTX | Servo Motors and Drives | 2 | 03-15-2005 04:31 PM |
| | |
Linear Mode
