Four Carriages on Two 15mm Rails or a Single Carriage on a Single 45mm Rail ??? - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Mechanical Engineering > Linear and Rotary Motion
Four Carriages on Two 15mm Rails or a Single Carriage on a Single 45mm Rail ???

Linear and Rotary Motion Discuss ball/Acme screws, R&P, linear slides and theory here.

This forum is sponsored by:

Page 2 of 2

#13

10-07-2008, 06:08 AM

joprinz

Join Date: Oct 2007

Location: India

Posts: 75

permalink

Thanks Lee, Ken, Bob, Richard, Zumba, Vishnu and Jason. I have finally decided on using the 4x15mm design.

I will be starting a Build log thread once I start my build. Thank you once again for your inputs.

Joe!

Page 2 of 2

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Single vs Dual Lead Screws	Cold Fusion	DIY-CNC Router Table Machines	5	03-08-2009 04:26 PM
HSR TYPE RAILS CARRIAGES-used condition issue?	mobus1	Linear and Rotary Motion	5	03-24-2008 09:38 PM
THK rsr 15 rails and carriages	endgrainguy	Linear and Rotary Motion	5	03-24-2008 09:47 AM
Dual rails redundant?	PsyKotyk	Linear and Rotary Motion	7	05-11-2006 09:28 PM
Rails to bearings to carriage to... drive system?	Losos	DIY-CNC Router Table Machines	2	01-11-2005 12:40 AM

All times are GMT -5. The time now is 12:04 PM.