| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Linear and Rotary Motion Discuss ball/Acme screws, R&P, linear slides and theory here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-25-2008, 07:16 PM
| |||
| |||
I was wonderinng how people align new installations of ballscrews? I'm not planning to do it but am really curious....When people swap out acme screws for ballscrews the new installation needs a very good alignment with the ways of each table segment. But the ballscrew bearings and ball nut will probably need new mountinng hardware and screw holes, how are the positions achieved ?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| X2 Ballscrews ??s | maxboostbusa | Benchtop Machines | 5 | 12-05-2007 07:38 AM |
| Ballscrews | itsme | Benchtop Machines | 7 | 07-10-2006 02:22 PM |
| different ballscrews ? | ironDigit | Linear and Rotary Motion | 1 | 06-10-2006 10:42 AM |
| How Bad is it Without Ballscrews? | wallyblackburn | Bridgeport and Hardinge Mills | 16 | 01-17-2006 02:30 PM |
| Ballscrews on E Bay | mxtras | Linear and Rotary Motion | 0 | 09-07-2005 03:50 PM |
| | |
Linear Mode
