How to set up two screws for my X axis - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Mechanical Engineering > Linear and Rotary Motion
How to set up two screws for my X axis

Linear and Rotary Motion Discuss ball/Acme screws, R&P, linear slides and theory here.

This forum is sponsored by:

12-16-2007, 08:06 PM

dan dimock dan dimock is offline

Join Date: Dec 2006

Location: USA

Posts: 204

How to set up two screws for my X axis

permalink

I would like pictures and any help and information I can get on putting 2 half inch 10 tpi acme rods on my unit to drive the X axis.
I now have one down the center, and need my unit where it will cut one half inch material with a 1/16 inch bit and make three passes and be on the money. I am cutting wooden clock gears and now my unit will get off.
Dan Dimock

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
z axis ball screws	mddolson	Smithy	2	04-03-2007 02:01 PM
Ball screws, Acme screws, threaded rod	DJ Morrow	DIY-CNC Router Table Machines	11	03-22-2007 12:39 PM
Take out screws	vmax549	Bridgeport and Hardinge Mills	5	02-13-2006 10:22 AM
What Screws To Use For Mdf?	ljoe1969	DIY-CNC Router Table Machines	12	04-27-2004 05:28 AM
Z-Axis and Ball Screws	samualt	DIY-CNC Router Table Machines	15	01-10-2004 02:10 PM

All times are GMT -5. The time now is 09:00 PM.