Excello Mill

[usfwalden]

I use the dspmc/ip controller with the amc 30a8 amps. I replaced my tachometers with us digital encoders with indexes. It cost me as much in machine work before even including the cost of the encoders as the pico systems converter boards cost. The tachometer without resolver isn't good enough.

[mike_Kilroy]

I just found e727 for sale on ebay - seller says it was x axis on HURCO machine..... maybe if there is a Hurco group on cnczone u shud post over there for motor spec too??

[torinwalker]

Hey guys,

It has been a long time. Just over two years since I picked each of your brains. I wanted to let you know that all of your help was not forgotten. I've since completed rebuilding that machine and have been using it very happily for some time now. It turned out to be an amazing machine. I'm now building a 4th axis for it, and eventually, a 5th.

If you ever get this, I've posted a pic under the project section - not much to look at, but I'm adding new projects as I go along. I expect in another year this will be full of great little projects.

Thank you, guys. Very much.

Walker Technologies, Inc. | Control Your World


Torin...