| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Linear and Rotary Motion Discuss ball/Acme screws, R&P, linear slides and theory here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-04-2006, 04:09 PM
| ||||
| ||||
Ok so I was just messin around with 80/20 profiles and looked at my mill. I said the big hmmmmmmmmmmmmmmmm. So if you configure the typical profiles like this you get a dovetail for sliding and a good mounting for a 5/8-8 acme screw. I'm thinking mill conversion now. The white gibbs are delrin or uhmw attached to the dovetail at full length. Anybody ever try this before?     Last edited by spunky1974; 11-06-2006 at 12:25 PM.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
