Need a source for this bearing mount/assembly

[SteveL]

I’m trying to locate a source for the bearing assembly or mount shown. I would prefer to use a factory assembly rather than machine one. It has 4 bearings, 2 each on 2 ¼” shafts. The stiffening web between the shafts blocks the view of the 2nd shaft in the photo. The exact dimensions aren’t critical. I would prefer something approx. 1”h (top to bottom in photo) x 1 ¼” to 1 ½” d (across the 2 shafts) x 4” to 6” long (right to left in photo).

Any help locating a source would be greatly appreciated.

Thanks

[NC Cams]

Better plan on machining one as that one surely was custom machined by SOMEBODY.

You might also check Stock Drive Products as they sometimes have pre-machined prototype stuff like this.

It is impossible to see/figure out what kind of bearings are used to support the shaft from the photo but they are probably either metic or inch series small bore bearings of some type or another.

[SteveL]

NC, Thanks for the info. The bearings are 1/4" ID linear bearings held in place by clips.

OK guys, any other suggestions?