Lube - CNCzone.com-The Largest Machinist Community on the net!

monte55 · #1 09-16-2006, 10:55 AM

I have built a cnc table and am using linear bearings on X & Y. Some are open and some are closed and they all have wipers if that's correct. My question is what type of lubricant should I use in the bearings? There is no oil hole or tube. I would have to slide the bearing off, pack it and reinstall. Can I use machine oil, white lithium or whatever. Please no guesses. Thanks

NC Cams · #2 09-17-2006, 01:32 PM

Shell Alvania #2 is an approved grease for the trolleys on ball equipped linear guides. Mine have grease fittings thus it is easy to regrease them as needed.

monte55 · #3 09-17-2006, 05:42 PM

Originally Posted by NC Cams

Shell Alvania #2 is an approved grease for the trolleys on ball equipped linear guides. Mine have grease fittings thus it is easy to regrease them as needed.

Thank you for your answer ................Nick

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)