| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Linear and Rotary Motion Discuss ball/Acme screws, R&P, linear slides and theory here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-23-2005, 10:44 PM
| ||||
| ||||
I have just bought some new Gecko G202's that will run a 270oz and 1200oz stepper. I now need to know what size pinion and rack that i need to buy. Like what angle/pitch, how many teeth etc. Also where to buy from, I am in Australia. I do not mind buying from over-seas. Cheers Peter    |
|
#2
07-23-2005, 11:27 PM
| ||||
| ||||
| I believe Misumi will ship to Queensland out of Singapore, They have a huge free catalogue full of hardware. Although they do not appear to stock 14.5deg pressure angle rack. But 20deg is fine especially if the load is not really heavy. For a small table you could go with 20 diametral pitch with 12 at the largest. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
07-24-2005, 10:45 AM
| ||||
| ||||
| This is their worldwide website http://www.misumi.co.jp/world/index.html Here in N.A. Boston Gear is a very cost effective supplier but I suspect they may not be available in Australia. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#5
08-10-2005, 06:29 AM
| |||
| |||
| try T.E.A. transmission. www.tea.net.au. They are just north of Brissy. |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
