I have an issue that sometimes the drives on my X axis go into to protect mode, cause I'm using the built in parameters for a non Leadshine motor.

I'm very happy with the settings used for the motor, except the times when it goes into protect mode, cause I suspect the motors of pulling more amps than the built in parameters are allowing.

Is there any way of changing the built in parameters in the drives? I would like to try and add just a little more juice to the X axis drives, to see if that will have any effect.

I like the fact that my motors are running rather quietly, so I will not be making a set of parameters from scratch, just to have them sound like el cheapo drives again.. Have tried that, and at low speeds it will sound like it's vibrating itself apart.

So a chance to change the paramters that I'm using right now.

I have the cable, and the software, but last time I tried something like that, I ended up having to copy all the settings from one drive to another, to make it work as it should again.

Similar Threads: