I wouldn't.
You should be using grease.
WD-40 is not a lubricant.
hi team
can I use some spray like (WD-40) AND (A40 MAJIC)for ball screw and liner guide for lubricating my cnc ?
any advises please .
Similar Threads:
I wouldn't.
You should be using grease.
WD-40 is not a lubricant.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
as i read here that the grease cause problems ...
what type of grease you mean ?
what about oil ?
The manufacturer of your rails should have a recommended grease.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)