- Leadshine technical support available on CNCzone.com
-
Member
Re: Leadshine technical support available on CNCzone.com
I was wondering what the pinout for the serial RJ11 connector is on the HBS86H?
I cannot find it in any documentation from Leadshine?
Thanks.
-
-
Member
Re: Leadshine technical support available on CNCzone.com
Hello , I just start having an issue with my MX4660, I have 3 push buttons connected to input 1, 2 and 3 fot cycle start, feed hold and stop cycle, +12v connected to OPTO1. They were working right but suddenly they are no longer working, I verified the volt between push buttons terminals (NO push buttons) they show 11.2v in normal state and drop to 2volt when I press the push butons. Any help where should i need to look for
-
Member
Re: Leadshine technical support available on CNCzone.com
Hello Leadshine,
Is it possible to buy replacement board for stepper motor driver DMA860H ? How much ?
- Leadshine technical support available on CNCzone.com
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules