| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| LazyCam Discuss LazyCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-07-2009, 09:05 PM
| |||
| |||
 How do you set the rapid height on Z How do you set the rapid height on Z? When I post the code to mach3 everything is good but the Z is set to 60. I have a home build Plasma and like to cut a Z0. I cannot find a way to edit lazycam to set it for 2. I did find some type 0 errors in the Plasma.pst file and I did correct them. The error caused it to post this code. ( G4.09\nM5(Plasma Off)" ) I did edit that and it workds ok now. But still looking for a way to set the height of the Z for my Machine. DC    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Z axis goes to rapid height after each pass | Sonicmook56 | LazyCam | 5 | 04-01-2011 11:18 AM |
| Newbie- Rapid height? Basic router setup help | Ranscon | WoodWorking | 5 | 10-14-2008 08:29 PM |
| increasesing rapid on SL-30 | MBG | Haas Lathes | 1 | 10-06-2008 06:44 AM |
| rapid travel | iccirvr | Mach Mill | 8 | 05-20-2008 12:10 AM |
| Torch Height Control / Capacitive Height Control | ahlbebuck | Open Source Controller Boards | 0 | 11-27-2006 02:32 PM |
| | |
Linear Mode
