Results 1 to 1 of 1

Thread: strange offsets

  1. 07-30-2009, 03:55 PM #1
    Poul M A
    Poul M A is offline
    Registered
    Join Date
    Jul 2009
    Location
    Denmark
    Posts
    10
    Downloads
    0
    Uploads
    0

    strange offsets

    I have a problem with offsets. And I would be much obliged if some one would take a look at the letters in this file (zipped lcam). Especially around n and m letters
    Best Regards
    Poul M Andersen
    Attached Files Attached Files

« Too simple conversion in LazyCam | How do you set the rapid height on Z »

Similar Threads

  1. Strange PM Must be SPAM
    By duluthboat in forum Forum Questions or Problems
    Replies: 2
    Last Post: 04-13-2009, 01:12 AM
  2. CNC strange problem
    By huben_123 in forum TurboCNC
    Replies: 4
    Last Post: 03-14-2008, 07:12 PM
  3. strange 021 alarm -OMC
    By OC_ in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 1
    Last Post: 01-21-2008, 09:09 PM
  4. Strange Questions?
    By SPEEDRE in forum General Metalwork Discussion
    Replies: 4
    Last Post: 12-06-2006, 12:07 PM
  5. Looking strange
    By CNCadmin in forum CNCzone Site News and Contests
    Replies: 0
    Last Post: 09-15-2005, 10:04 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.