Hi: I have noticed that when working with AutoCad to gereate the DXF and feed this to LazyCam the cuts generation that LazyCam picks is not the more efficient even after Auto cleaned, Remove Redundant, Minimize Geometry and Optimize the drawing. There is a lot of time lost in every project I have done so far. I wonder if there is a way to tell LazyCam which line is the beginning and in which cutting order it should walk. The way it picks its routes is crazy. I know you can change the cut directions and some other small things but you are very restricted to a line. I have experimented with a few lines with AutoCad to watch how LazyCam treated them and it’s very arbitrary. The cutting efficiency in LazyCam should be manual improved but I don’t have the knowledge of who to do it. Has some body work trying to correct this actions? Please some one that give me a hint. Thanks.