Is there anybody out there that can help me with a few problems using Lasercut 6.1 running a LT-1390 laser?
I have another laser using Lasercut 5.3 and everything is running great.
On the 5.3 there is a moving dot on the screen that always shows me where the laser is located. Is this feature on 6.1, because I can't find it?
The 6.1 will datum ok, but when I start a job it won't cut in a area 6" from the right side. When it tries to enter this area it stops at about 6" from the right side.The rest of the table will cut ok.
The company I bought the machine from has been absolutely no help at all. Everything they have told me has been wrong. The machine was a complete mess when I got. None of the electrical plugs were right for North America and they told me to plug it into 220 AC volts when in fact it was a 120 AC volt machine. I was lucky enough to catch this before I plugged it in.

Help Help Help Help Help
John Barnes
Barnes_Place@hotmail.com


Similar Threads: