Need Help! Soft Stop (MPC6515) - CNCzone.com-The Largest Machinist Community on the net!

spotbox · #1 09-23-2009, 09:41 AM

HI
how can I fix "Soft Stop" error message on machine Disply
I made a file with lasercut 5.3 and download it via USB Stick.
I hope anybody can help me
Thank you
bye
spot-box

SkipW · #2 09-23-2009, 03:18 PM

Spotbox,

First, with the laser on, you must Download Config to the laser from LaserCut using the usb cable. Or Export Config to your portable usb drive, then run it in the laser and it should beep when done.

Also see HERE for another soft stop error thread.

That's the best I can do. Does your DLL and Firmware match now? Did you get that fixed?

Skip

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Programming a MPC6515 controller	CARTOGATE	Redsail Laser	9	01-30-2010 02:09 AM
Problem- "Soft Stop" error MPC6515	KPBadger	Laser Engraving & Cutting Machines	3	02-25-2009 02:37 PM
Soft stop alarm	kayleesdad	General Metalwork Discussion	6	04-08-2005 10:26 PM
Soft stop over travel alarm	kayleesdad	Mazak, Mitsubishi, Mazatrol	0	04-06-2005 08:27 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)