Need Help!- lasercut

[LOLO80]

hi,
I used lasercut5.3 with laser machine ruijie 1200 X 900 mm, with servodrive panasonic, there is any one for give me all set parameters for well engrave, ( speed start, speed end, space, acc lenght, y acc.......
thanks
laurent

[maxxex]

Can you tell us what laser tube do you have (80w?), and what material do you want to engrave?
Maybe I can help you, I have very similar machine.

[LOLO80]

hi maxxex,
you have similar machine with servodrive?
i used this machine for cut and engrave a diferent thickness plexiglas,
the laser tube is 80 W

[maxxex]

No, not with servo drive, I have step motors, but machine size, laser tube and software are the same.
Is that some enhanced version? Does it also use MPC6515 controller?

[LOLO80]

no the control card is mpc 6575,
this just for control servo drive. in software the control is mpc 6515, and all set is same.

[maxxex]

Parameters should be the same, for plexiglas (acrylic) engraving I use speed 400, power 27 and line gap of 0.06 and I get good engraving quality, you should be able to run it even faster since you have servo motors. Do you use PWM or Analog signals to control laser?

[LOLO80]

I use pwm, do is good?
I would like know the seting in ( work mode, and engrave, in the software, can you send me please

[maxxex]

I can't help you much with PWM setting, I can't use them, because when I set to PWM I can't control power when engraving. I use Analog settings.